What are the common Reasons of Hard Disk Drive failure?

What are the common Reasons of Hard Disk Drive failure?

1. Electronic Component Failure
2. Motor Failure
3. Read / Write Head Failure
4. Media Damage
5. Firmware Corruption
6. Logical Failure

One or all of the above primary causes may be evident when diagnosing a failed hard disk drive.

Electronic Component Failure
Electronic components may fail due to voltage transients, heat or poor handling. Substitution, repair and re-programming is generally required in order to recover data stored on the hard disk. PCB assemblies are however hyper tuned at the manufacture stage and specialist re-programming and calibration is subsequently required to restore the hard disk to a working condition.

Motor Failure
Hard disk motor spindles have fluid bearings; sometimes this fluid leaks or becomes overheated and in-effective. The motor will then seize and the hard disk platters fail to rotate. Platter and component re-location to another hard disk assembly is required to effect a repair and restore data.

Read / Write Head Failure
Read / write heads are aerodynamically designed to “fly” at nanometer distances above the surface of the platters. Ceramic thin film sensors at their tip detect magnetic information (data) stored on the surface of the platter. Occasionally the atmosphere in the hard disk enclosure will become contaminated or vibration will cause the dynamic of the head to be disturbed. This disturbance will cause the read /write process to malfunction resulting in bad data read write cycles and eventual failure.
This type of failure usually manifests itself as a distinct clicking noise as the head actuator makes failed repeat attempts to locate data at the same platter track location.

Media Damage
Amazingly all computer hard disk magnetic storage media is manufactured imperfect but to acceptable and controllable levels. During normal operations imperfections will sometimes increase above the predefined acceptable level. This can be due to heat, vibration, head crash, shock or other factors. The operating system will flag errors or fail to boot and data files will then become in-accessible. Read/.Write head replacement and file repair will allow data file structures to be examined and assessed as to their validity.

Firmware Corruption
Hard disk firmware holds precise parameters relevant to the configuration of the assembly at the time of manufacture. Occasionally the firmware becomes corrupt or will “roll back” to an incorrect set of parameters. Under these conditions the location of the stored data as reported to the operating system will be lost. Simple restoration of the correct parameters will allow the hard disk to function correctly. What causes this corruption? Operating system to drive software bugs, control bus protocol failure, it is difficult to determine but failures do occur.

Logical Failure
Data files are stored at logical locations that relate to a number of physical locations on the surface of the hard disk platters. These logical locations are held in tables by the operating system and indexed when running specific software applications. Operating system errors, reloads or incorrect upgrade applications will sometimes corrupt these tables and data will become in-accessible. This is generally referred to as a logical failure. Logical errors can be repaired with software tools available from the internet. Be cautious however - if you are intending to run a fix utility on your disk you can inadvertently damage these tables irreparably and your data will be unrecoverable. This is especially true when running ScanDisk and Chkdsk on a damaged hard drive.